![]() ![]() ![]() For most songs you’ll want to start with this on moderate-high so start at around 7 and work from here. The mids control is very important and affects how full the tone is. If it sounds a bit too loose and muffled, lower it and if it sounds thin then increase it. The bass control normally sounds best around midway so start at about 5 and adjust from here. The more bass there is, the more “boomy” and looser the tone will be. ![]() The bass control adjusts how much low-end the tone will have. Some amplifiers have a single tone/EQ control whereas others have individual bass, mids and treble controls which allow you to shape the tone a bit more freely. You may also want to use a pedal instead for your gain as David Gilmour often used a fuzz pedal (more on this later). If you’re using a solid state amplifier, you’ll want to start at around 4-5 for songs like Another Brick in the Wall, slightly lower for songs like Money and as low as 2 for songs like Shine On You Crazy Diamond. If you’re using a tube amp, you’ll need to crank it so it is mildly overdriven but not distorted. The amount of gain you’ll need really does depend on the song and what type of amp you’re using. If you’re using single coil pickups, you’ll need to compensate by boosting the mids and bass on your amp more and cutting the treble, whereas if you’re using humbuckers then you’ll need more treble and less bass and mids. In general, you’ll want low-mid levels of gain, a boosted mid-range, and a bit more bass than treble. They of course will vary from song to song and depending on what equipment you’re using which we will address a bit later on. Before we jump into some specific songs, let’s go through the basic controls and explain where is a good place to start. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |